Adjusting The Signature Scanner - Polaroid ID-3000 Repair Manual

Polaroid ID3000 Service Manual

Adjusting the Signature Scanner

NOTE: Before performing the Signature Scanner adjustment steps 1 - 8 below,
first verify that the two switches and the thumbwheel on the Logitech
Scanner are set as follows:
a.
b.
c.
Looking at the Scanner from the rear, on the left side, set the switch nearest
the front (gray level or bi-level) to the / position ("a" in Figure 2-46).
Also on the left side of the Scanner, set the thumbwheel
(contrast adjustment) to the center position ("b" in Figure 2-46).
(If the signature on a finished print is too light or dark, move the
thumbwheel toward the light or dark band accordingly.)
Finally, on the right side of the Scanner, set the dots/inch switch at "2"
("c" in Figure 2-46).
Figure 2-46 Signature Scanner switch settings
2-48
System Installation