Polaroid ID3000 Service Manual
Replacing the Portrait Camera
1.
Unpack the new portrait camera and save all packing materials. Verify that the switch in
the lower left corner of the rear panel of the new camera is set to the right-hand position
(see Figure 5-1).
Figure 5-1 Set Camera Switch to right-hand position
2.
Shut off the power switch on the CI-5000 Assembly or the Thermal Printer Assembly.
3.
Disconnect the cables from portrait camera.
4.
Remove the camera from camera bracket by loosening the knurled screw from the
bottom (Figure 5-2).
Figure 5-2 Removing Camera from Bracket
5-3
Parts Replacement