Table of Contents
Advertisement
Polaroid ID3000 Service Manual
8.
When you are finished responding to the first-time-only installation questions, you are
asked whether you want to stop now and save the current configuration, or go on to make
further changes to the Carbon Copy PLUS configuration.
o
Type X to complete the installation process and use the current Carbon Copy
PLUS configuration.
o
Press any other key to continue configuring Carbon Copy PLUS. Type X to exit
the configuration program and save your changes when you are finished.
9.
After you type X to finish the first-time-only installation and configuration, Carbon Copy
PLUS creates the following configuration files. These files are updated each time you
configure Carbon Copy PLUS:
CC30.CFG
MM30.CFG
10.
Repeat steps 2 - 9 above for the Host master diskette on the host PC.
11.
Make a working copy of Carbon Copy on the hard disk.
WARNING:
12.
Place a write-protect tab on the Guest and Host master diskettes.
13.
Make a C:\CCPLUS directory on the C: drive and change it to:
C:
CD
MD CCPLUS
CD CCPLUS
14.
Insert the Guest master diskette into drive A: and at the C:\CCPLUS> prompt, type
COPY A:*.*
15.
In the same way, copy the Host master diskette and Utilities diskette onto the C: drive,
using the step 14 COPY command.
Do not copy any files from the master diskettes before
you run the first-time-only installation procedure described
In the previous section. Any other action may destroy your
master diskettes.
5-49
Parts Replacement
Advertisement
Chapters
Table of Contents
Troubleshooting
