Polaroid ID-3000 Repair Manual page 136

Error Message
No.
214 CFR Pull Film Error
215 CFR Timeout On Response
216 CFR Query Back Type
217 CFR Turned Off
218 CFR Not Found Or Not
Present
250 Thermal Printer Initialization
Error
251 Thermal Printer Status Error
Probable cause
Disconnected or loose film
holder cable.
Faulty film pull button in film
holder.
Film recorder turned off.
Loose or broken serial cable
to film recorder.
Disconnected or loose film
holder cable.
Loose or broken serial cable
to film recorder.
Film recorder turned off or
serial cable disconnected.
Loose or broken serial cable
to film recorder.
Wrong CFR "ON/OFF"
setting in HOC_CI5K.CNF.
Film recorder turned off or
serial cable disconnected.
Loose or broken serial cable
to film recorder.
Thermal Printer is off or not
connected properly.
Thermal Printer is displaying
error code.
3-54
Corrective action
Check film holder cable and reconnect
or tighten as necessary.
Check film pull button and repair or
replace as necessary.
Turn film recorder on.
Check serial cable and connections;
tighten connections or replace cable if
necessary.
Check film holder cable and reconnect
or tighten as necessary.
Check serial cable and connections;
tighten connections or replace cable if
necessary.
Verify that film recorder is on and the
serial cable is connected.
Check serial cable and connections;
tighten connections or replace cable if
necessary.
Check CFR "ON/OFF" setting in
HOC_CI5K.CNF and correct if
necessary. (See CNF filed and Typical
Contents in Section 3)
Verify that film recorder is on and the
serial cable is connected.
Check serial cable and connections;
tighten connections or replace cable if
necessary.
Turn OFF the ID System. Connect all
the cables to the thermal output unit
and turn all components ON.
Check the front panel of the thermal
printer. Check the counter for error
display and/or any flashing light on the
printer. Ready light on the thermal
printer is not ON steady.