Table of Contents
Advertisement
Polaroid ID3000 Service Manual
Select QUIT
NOTE: If you continually experience any Matrox board errors, exit to DOS and follow
the complete configuration procedure (see Page 5-17).
13.
The final screen instructs you to reboot the system, or to press <Esc> if you need to
change AUTOEXEC.BAT or CONFIG.SYS manually before rebooting. Changes may be
required when non-standard hardware has been installed in the system.
If needed, press <Esc> and make any required changes to these files.
14.
Now reboot the system. The system will prompt you to log in and the main menu should
appear.
15.
To install any optional modules, select INSTALL SOFTWARE UPDATE from the
Utilities menu for each module.
IMPORTANT: YOU MUST INSTALL ANY OPTIONAL MODULES
16.
You need not reboot the system unless instructed on the screen to do so.
17.
To install the customer software, select INSTALL SOFTWARE UPDATE from the
Utilities menu.
18.
Now calibrate and test the system, following the procedures in Sections 2 and 4 of this
Manual.
Select YES
BEFORE INSTALLING THE CUSTOMER APPLICATION, since the
customer application may replace and/or relocate some of the standard
files.
5-54
Parts Replacement
Advertisement
Chapters
Table of Contents
Troubleshooting
