Verifying Applicant Data - Polaroid ID-3000 Repair Manual

Polaroid ID3000 Service Manual

Verifying Applicant Data

1. Select Verify Applicant from the Issue and Verify menu to display the applicant category
window.
2. Select the appropriate applicant category to bring up the data entry screen.
3. Type the applicant's ID card number used to make the identification card in the previous
section (the corresponding data should be stored in the system), then press <F10>. The
applicant data should appear on the monitor, along with the applicant's portrait. (Waiting . . .
may appear while the information is being retrieved.)
If the information is not available, No Matching Records Found appears in the center of the
screen. Try a second time to retrieve the stored data, by repeating step 3. If the message
No Matching Records Found appears again, press the space bar to remove the message.
Then you can enter another ID card number and press <F10> to search again.
You can also use the ID-3000 enhanced search feature described in the operator's
instructions to locate the applicant's record.
4. Check the data, portrait and signature for accuracy and image quality. If more than one
screen of data exists for an applicant, use <Page Up> and <Page Down> to view data.
NOTE: If any of the three elements does not display properly (data, portrait or
signature), press <Esc> to return to the data entry screen and repeat steps
3 and 4. If the displayed items are still unsatisfactory, perform the
appropriate troubleshooting procedure in Section 3 of this manual.
5. Any attempt to edit the data displayed is impossible.
6. Verify another applicant by typing a new applicant ID card number (a number not
previously entered or stored in the system), then press <F10>. The message No matching
records were found. Press any key to continue should appear.
7. Press <Esc> to return to the Issue and Verify menu.
2-29
System Installation