Polaroid ID-3000 Repair Manual page 202

Polaroid ID3000 Service Manual
5. Remove the two covers on the new camera by unscrewing the six screws; make sure the
Automatic Gain switch is OFF (Refer to Figure 5-3A for switch positions.
Figure 5-3 Remove auto-iris lens and mount on replacement camera
6. Remove the auto-iris lens from the portrait camera (Figure 5-3) and install it on the
replacement camera.
Figure 5-3A Remove the two covers on the camera
7. Attach the camera to the bracket and support arm (Figure 5-2) with the Focus and Lock
screws on top, facing front.
8. Reconnect the camera cables to the camera.
9. Power up the system according to the operating instructions.
10. Perform the Illuminator Board Calibration procedure described in Section 4 of this Manual.
11. Perform functional check described in Section 2.
12. Repackage the replaced portrait camera for return shipment.
5-4
Parts Replacement