Replacing The Computer - Polaroid ID-3000 Repair Manual

Polaroid ID3000 Service Manual

Replacing the Computer

1. Shut off the entire ID-3000 system according to the operating instructions.
2. Unplug the computer power cable from the back of the computer.
3. Disconnect all other cables from the back of the computer.
4. Carefully unpack the replacement computer.
NOTE: Install hard drive, tape drive and any new circuit boards or boards out of the
computer being replaced before proceeding further. (See the following procedure for
computer circuit board replacement.)
5. Connect all cables to the rear of the computer according to cable installation instructions
in Section 2.
6. Power up the system according to the operating instructions.
7. Perform the functional check procedure in Section 2 and complete any calibration proce
dures (Section 4) indicated by the functional check.
8. Repackage the replaced computer as shown in Figure 5-14.
Figure 5-14 Computer packaging
5-14
Parts Replacement