Polaroid ID-3000 Repair Manual page 245

Polaroid ID3000 Service Manual
To Install Sytos in a Standalone ID-3000 Ver. 2.x System:
The following three disks are associated with Sytos software:
1. Insert the SY-TOS Tape Operating System disk in drive A.
From the C: prompt, type A: and press <Enter>.
2. Type STINSTALL and press <Enter>.
3. The batch file will then install the software and prompt you when to insert the second disk
into drive A.
4. Answer the question asking which drive the software is being installed in, by typing C: and
pressing <Enter>.
5. Answer the question asking which directory it is to be installed in, by typing \SYTOS and
pressing <Enter>.
If a Cipher tape drive is installed, do step 7. If a Viper tape drive is installed, go to step 8.
6. After these two disks have been installed, insert the Future Domain SY-TOS Add In
Driver diskette into drive A. Type TINSTALL C: and press <Enter>.
7. This will install the required driver into the SYTOS directory.
8. Reboot the system and perform the functional check described in Section 2.
9. For the File Backup and Restore Menu option to work correctly from the ID3000
software, you need to include a file called Backup.Lst in the Systos directory. This file is
located in the Customer Application floppy disk. It includes the different hard drive
partitions; for example: If the system has 180MB hard drive which has partitions C, D and
E, then the Backup.Lst file will be like the following - if you use the DOS type <file name>
command.
C:\
D;\
E;\
This will tell the Systos software to backup drives C, D and E.
Disk 1 SY-TOS Tape Operating System
Disk 2 SY-CLOCK Unattended Software Administrator
Disk 3 Future Domain SY-TOS Add In Driver
5-47
Parts Replacement