Polaroid ID-3000 Repair Manual page 146

Error Message
No.
824 Signature Controller Enhance
Buffer Support
825 Signature Controller Error
Getting Coordinates
826 Signature Controller Setting
Coordinates
827 Signature Controller DMA
Buffer Error
828 Signature Card Configuration
Error
830 CFR Load SOT file
831 CFR Error Getting Port
Number
832 Get FilmTab Error
833 Error Getting CFR Bulletin
Board Parameter
834 CFR Menu Error
835 CFR Window Error
851 Thermal Printer Bulletin
Board Parameter Error
Probable cause
Signature coordinates too
large.
Faulty image capture ("Paris")
board.
Unable to find
SIS_SCAN.CNF.
Unable to find
SIS_SCAN.CNF.
Application Software
Problem.
Application Software
Problem.
Unable to find
HOC_SCRN.SOT
Incorrect serial port number
specified in HOC_CI5K.CNF.
Unable to determine number
of exposures remaining.
Corrupted EMS memory.
Corrupted or missing
HOC_SCRN.SOT.
Corrupted or missing
HOC_SCRN.SOT
Applications Problem.
3-64
Corrective action
Check the X and Y coordinates in
SIS_SCAN.CNF and correct if
necessary. (Maximum: 500 x 500.)
Run Image Board calibration and
diagnostics and repair or replace as
necessary.
Verify that SIS_SCAN.CNF is
installed and correct path is specified,
ID2DATA directory.
Verify that SIS_SCAN.CNF is
installed and correct path is specified,
ID2DATA directory.
Contact the Service Center.
Contact the Service Center.
Verify that HOC_SCRN.SOT is
installed and correct path is specified,
ID2DATA directory.
Check the setting of CFR_PORT in
HOC_CI5K.CNF. See CNF Files and
Typical Contents in Section 3.
Verify that HOC_CI5K.CNF is
installed and correct path is specified,
ID2DATA directory.
Check for and resolve EMS memory
conflicts; check EMS driver.
Reinstall HOC_SCRN.SOT.
Reinstall HOC_SCRN.SOT.
Contact the Service Center.