Inspection - Suzuki DL650 Service Manual

8-20 ELECTRICAL SYSTEM
SIDE-STANDIIGNITION INTERLOCK
SYSTEM PARTS INSPECTION
Check the interlock system for proper operation. If the interlock
system does not operate properly, check each component for
damage or abnormalities. If any abnormality is found, replace
the component with a new one.
SIDE-STAND SWITCH
Remove the left frame cover.
( - 7 - 5 )
Disconnect the side-stand switch coupler
@
and measure the
voltage between BlacldWhite and Green lead wires.
rn
09900-25008: Multi circuit tester set
;m
Tester knob indication: Diode test (fe)
Side-stand up
@
- - -
NOTE:
If the tester reads under 1.4 V when the tester probes are not
connected, replace its battery.
Side-stand down @ I
GEAR POSITION SWITCH
Remove the left frame cover. (-7-5)
Disconnect the gear position switch coupler and check the
continuity between Blue and BlacWhite with the transmis-
sion in "NEUTRAL".
rn
09900-25008: Multi circuit tester set
r m
Tester knob indication: Continuity test ( 4 ) )
BlacWhite
(@ probe)
1.4 V and more
(Tester's battery voltage)
Green
(@
probe)
I
ON (Neutral)
1
-
I
0.4
-
0.6
V
Blue BlacWhite
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
OFF (Expect neutral)
I