Suzuki DL650 Service Manual page 135

3-84 ENGINE
When securing the right and left crankcase halves, tighten
each bolt a little at a time to equalize the pressure. Tighten all
the securing bolts to the specified torque values.
rn
Crankcase bolt: (M8) 26 N-rn (2.6 kgf-rn, 19.0 Ib-ft)
(M6) 11 N-rn (1.1 kgf-rn, 8.0 Ib-ft)
/
CAUTION
I
Do not drop the O-ring into the crankcase when
assembling the right and left crankcase halves.
NOTE:
*
After the crankcase bolts have been tightened, check if the
crankshaft, the driveshaft and the countershaft rotate
smoothly.
* Fit the clamp to the bolt
0
as shown.
OIL PLATE
Install the oil plate @I and the oil plate bolts tighten to the
specified torque.
rn
Oil plate bolt: 10 N-rn (1.0 kgf-rn, 7.0 Ib-ft)
ENGINE SPROCKET SPACER
lnstall the new O-ring into the engine sprocket spacer
@.
p i i % %
I
Use the new O-ring to prevent oil leakage.
1
Install the engine sprocket spacer
@
NOTE:
*
The grooved
@
side of the engine sprocket spacer @I must
face crankcase side.
*
Apply SUZUKl SUPER GREASE to the oil seal lip and O-ring.
99000-25030: SUZUKl SUPER GREASE "A" (USA)
99000-25010: SUZUKl SUPER GREASE "A" (Others)