E N G I N E
3-63
Gradually press out the bearing with the special tool by using
the hand-press.
The removed bearings must be replaced with new
ones.
@
Hand-press
@
Crankcase
@
Bearing
NOTE:
Using the hand-press is recommended to remove the crankshaft
-
journal bearings. However, the crankshaft journal bearings can
be removed by using with the following special tools.
a
09924-84510: Bearing installer set
0991 0-201 16: Conrod holder
0991 3-60221 : Journal bearing remover/installer
Set the specified crankshaft journal bearings
to
the special
tool.
Before setting the bearing, apply enough engine oil
to the special tool and bearings.
When setting the bearing, align the bearing side with
the engraved line
@
and also the bearing end with
the mating surface of the special tool.
NOTE:
The upper and lower bearings are same.