Cooling Fan; Inspection; Removal; Installation - Suzuki DL650 Service Manual

6-8 COOLING AND LUBRICATION SYSTEM
COOLING FAY
INSPECTION
Remove the cowling. ( W 7 - 5 )
Disconnect the cooling fan motor and thermo-switch lead wire
coupler
O.
Test the cooling fan motor for load current with an ammeter con-
nected as shown in the illustration.
The voltmeter is for making sure that the battery
applies 12
volts to the fan motor
(3.
With the fan motor with electric motor
fan running at full speed, the ammeter
@
should be indicating
not 5 amperes and more.
If the fan motor does not turn, replace the fan motor assembly
with a new one.
NOTE:
When making above test, it is not necessary to remove the cool-
ing fan.
REMOVAL
Remove the cowling. ( W 7 - 5 )
Drain the engine coolant. (-2-1 8)
Remove the radiator. ( W 6 - 4 )
Disconnect the cooling fan thermo-switch coupler
a.
Remove the cooling fan.
INSTALLATION
Install the cooling fan to the radiator.
Cooling fan motor mounting bolt:
8 N-m (0.8 kgf-m, 6.0 Ib-ft)
Connect the cooling fan thermo-switch coupler
a.
Install the radiator.
Route the radiator hoses properly. (-9-24)
Pour engine coolant. (-2-1 8)
Bleed the air from the cooling circuit. (-2-1 9)
Install the cowling. ( W 7 - 8 )