Suzuki DL650 Service Manual page 210

4-50 FI SYSTEM DIAGNOSIS
IAT SENSOR INSPECTION
The intake air temperature sensor is installed on the right side of
the air cleaner box. (-4-33)
IAT SENSOR REMOVAL AND INSTALLA-
TION
Lift and support the fuel tank. (-5-7)
Remove the IAT sensor from the air cleaner box.
Install the IAT sensor in the reverse order of removal.
IAT sensor: 18 N-m (1.8 kgf-m, 13.0 Ib-ft)
TO SENSOR INSPECTION
TO SENSOR REMOVAL AND INSTALLATION
The tip over sensor is located in under the seat. (-4-35)
Remove the right frame cover. (-7-5)
Remove the TO sensor from the rear fender.
Install the TO sensor in the reverse order of removal.
NOTE:
When installing the TO sensor, the " U P mark
@
must be
pointed upward.
STP SENSOR INSPECTION
STP SENSOR REMOVAL AND INSTALLA-
TION
The secondary throttle position sensor is installed at the left side
of the No.2 throttle body.
Remove the air cleaner box. (-5-1 5)
Remove the STP sensor. (-5-1 9)
Install the STP sensor in the reverse order of removal.
rn
STP sensor mounting screw: 2.0 N.m (0.2 kgf-m, 1.5 Ib-ft)
STP SENSOR ADJUSTMENT
Adjust the STP sensor. (-5-28)
H02 SENSOR INSPECTION (E-02,19)
H02 SENSOR REMOVAL AND INSTALLA-
TION
The H02 sensor is installed at the exhaust pipe.
Remove the seat. (-7-4)
Disconnect the H02 sensor lead wire coupler and remove the
H02 sensor.
Install the H 0 2 sensor in the reverse order of removal.
rn
H02 sensor: 47.5 N-m (4.75 kgf-m, 34.3 Ib-ft)