Suzuki DL650 Service Manual page 136

ENGINE 3-85
GEAR POSITION SWITCH
lnstall the gear position switch contacts and springs.
-
Apply SUZUKl SUPER GREASE to the O-ring
Q
and then
install it onto the gear position switch.
99000-25030: SUZUKl SUPER GREASE "A" (USA)
99000-25010: SUZUKl SUPER GREASE "A" (Others)
lnstall the gear position switch
@
as shown.
Tighten the gear position switch bolt to the specified torque.
rn
Gear position switch bolt: 6.5 N*m (0.65 kgf-m, 4.7 Ib-ft)
lnstall the drive shaft oil seal retainer
@.
NOTE:
Pass through the gear position switch lead wire under the drive-
-
shaft oil seal retainer.
FRONT CAM CHAIN
lnstall the front cam chain
6 ) .
lnstall the cam chain tensioner
a,
washer
@
and cam chain
tensioner bolt
@.
Tighten the cam chain tensioner bolt @ I to the specified
torque.
rn
Cam chain tensioner bolt: 10 N-m (1.0 kgf-m, 7.0 Ib-f)
NOTE:
The front and rear cam chain tensioners are the same.