Battery; Specifications; Initial Charging - Suzuki DL650 Service Manual

Hide thumbs Also See for DL650:

Table of Contents

8-40 ELECTRICAL SYSTEM

SPECIFICATIONS

Upper cover breather

Cathode plates

Safety valve

Anode plates

Separator (Fiberglass plate)

Type designation

INITIAL CHARGING

Filling electrolyte

Remove the aluminum tape

sealing the battery electrolyte

filler holes

12 V, 36.0 k c (1 0 Ah)/lO HR

When filling electrolyte, the battery must be removed from the

vehicle and must be put on the level ground.

Remove the caps

After filling the electrolyte completely, use the removed cap

as the sealed caps of battery-filler holes.

Do not remove or pierce the sealed areas

of the electrolyte

Insert the nozzles of the electrolyte container

into the bat-

tery's electrolyte filler holes, holding the container firmly so

that it does not fall. Take precaution not to allow any of the

fluid to spill.

Make sure air bubbles

are coming up each electrolyte con-

tainer, and leave in this position for about more than 20 min-

Show Quick Links

Chapters

Table of Contents

2004 dl650k4 Dl 650 2004