Suzuki DL650 Service Manual page 323

7-52 CHASSI S
SWINGARM BEARING
Insert the spacer into bearing and check the play when moving
the spacer up and down.
If excessive play is noted, replace the bearing with a new one.
Remove the swingarm pivot bearings and spacer with the
special tool.
a
09921-20240: Bearing remover set (25 mm)
I
DO not reuse the removed bearings.
I
Remove the cushion rod bearings with the special tool.
rn
09921 -20240: Bearing remover set (1 7 mm)
I
CAUTION
I
/
DO not reuse the removed bearings.
I
SWINGARM PIVOT SHAFT
Using a dial gauge, check the pivot shaft runout and replace it if
the runout exceeds the limit.
09900-20607: Dial gauge (11100 mm, 10 mm)
09900-20701 : Magnetic stand
09900-21 304: V-block (1 00 mm)
Swingarm pivot shaft runout:
Service limit: 0.3 mm (0.01 in)
CUSHION LEVER BEARING
Insert the spacer into bearing and check the play when moving
the spacer up and down.
If excessive play is noted, replace the bearing with a new one.