Suzuki DL650 Service Manual page 378

ELECTRICAL SYSTEM 8-21
Connect the gear position switch coupler to the wiring har-
ness.
Turn the ignition switch to "ON" position and side-stand to
upright position.
Insert the needle pointed probes to the gear position switch
coupler.
Measure the voltage between Pink and BNV lead wires using the
multi circuit tester when shifting the gearshift lever from low to
top.
09900-25008: Multi circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: voltage (V)
Gear position switch voltage
Gear
position
NOTE:
* When connecting the multi circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
* Use a needle pointed probe outer diameter being below
0.5
mm to prevent the rubber of the water proof coupler from dam-
age.
Voltage
-
-.--
--
-
--
TURN SIGNAUSIDE-STAND RELAY REMOVAL AND
INSTALLATION
The turn signallside-stand relay is composed of the turn signal
relay, side-stand relay and diode.
Remove the seat. (-7-4)
Remove the turn signallside-stand relay
0.
Install the turn signallside-stand relay in the reverse order of
removal.
1 st
Approx.
1.36 V
2nd
Approx.
1.77 V
3rd
Approx.
2.49 V
4th
Approx.
3.23 V
5th 6th
Approx.
4.10 V
Approx.
4.55 V