Inspection; Rear Shock Absorber Disposal - Suzuki DL650 Service Manual

7-46 CHASSIS
INSPECTION
Inspect the shock absorber body and bushing for damage and
oil leakage.
If any defects are found, replace the shock absorber with a new
one.
- 1
Do not attempt to disassemble the rear shock
absorber unit. It is unserviceable.
REAR SHOCK ABSORBER DISPOSAL
The rear shock unit contains high-pressure nitrogen
gas. Mishandling can cause explosion.
Keep away from fire and heat. High gas pressure
caused by heat can cause an explosion.
Release gas pressure before disposing.
GAS PRESSURE RELEASE
Mark the drill hole at
@,
shown in the illustration, with a center
punch.
Cover the rear shock absorber with a transparent vinyl bag
@.
Hold the rear shock absorber
Q
with a vice.
Make a hole with a 3 mm drill.
Be sure to wear protective glasses since drilling
chips and oil may fly off with blowing gas when the
drill bit has penetrated through the body.
Make sure to drill at the specified position. Other-
wise, pressurized oil may spout out forcefully.