Master Cylinder Removal And Disassembly - Suzuki DL650 Service Manual

CHASSI S 7-75
Tighten the brake caliper sliding pin
@
to the specified torque.
Brake caliper sliding pin: 27 N-m (2.7 kgf-m, 19.5 Ib-ft)
Apply SUZUKl SILICONE GREASE to the brake caliper slid-
ing pin.
&
99000-25100: SUZUKl SILICONE GREASE
Install the caliper to the caliper bracket
@.
Set the boot onto the brake caliper sliding pin
@
securely.
Install the brake pad. (-7-69)
Tighten the brake hose union bolt
6)
with the brake hose
union pipe seated in the cutout on the caliper.
(Rear brake hose routing:
-9-27)
-
Brake hose union bolt: 23 N-m (2.3 kgf-m, 16.5 Ib-ft)
p m m q
The seal washers should be replaced with the new
ones to prevent fluid leakage.
Bleed air from the system after reassembling the cal-
iper. ( W 2 - 2 5 )
MASTER CYLINDER REMOVAL AND DISAS-
SEMBLY
Drain the brake fluid. (-7-71)
-
Remove the brake fluid reservoir tank mounting bolt
@.