Starter Relay Inspection - Suzuki DL650 Service Manual

ELECTRICAL SYSTEM 8-19
STARTER RELAY INSPECTION
-
Remove the seat. ( W 7 - 4 )
Disconnect the battery
@
lead wire from the battery.
Remove the starter relay cover
6 ) .
Disconnect the starter relay coupler
@.
Disconnect the starter motor lead wire
@
and battery lead
,
1
wire
8.
Remove the starter relay
@.
Apply 12 V to
@
and
@
terminals and check for continuity
dl......l+-
between the positive and negative terminals using the multi cir-
cuit tester. If the starter relay clicks and continuity is found, the
relay is ok.
rn
09900-25008: Multi circuit tester set
Tester knob indication: Continuity test
( 4 ) )
/-mmGq
Do not apply a battery voltage to the starter relay for
five seconds and more, since the relay coil may over-
heat and get damaged.
Measure the relay coil resistance between the terminals using
the multi circuit tester. If the resistance is not within the specified
value, replace the starter relay with a new one.
09900-25008: Multi circuit tester set
1 )
Tester knob indication: Resistance (Q)
Starter relay resistance: 3
-
6 C2