Software Version Upgrade; Figure 3-8 Network Structure Of Automatic Configuration File Uploading - Zte ZXR10 2910E-PS Configuration Manual

Chapter 3 System Management

Figure 3-8 Network Structure of Automatic Configuration File Uploading

The network is shown in Figure 3-8. Before configuring the following commands, make
sure that the switch can ping the server successfully. Assume that the TFTP server
address is 10.40.89.78, and the configuration is save to the server once per 10 days. The
configuration commands are as follows:
zte(cfg)#set auto-saveconfig serverip 10.40.89.78
zte(cfg)#set auto-saveconfig period 10
zte(cfg)#set auto-saveconfig enable
Caution!
The enable command should be configured after the server IP is configured. If the server IP
is not configured, the system displays a prompt. The automatic uploading function cannot
be enabled successfully. If a communication exception occurrs between the switch and
the server when the uploading function is triggered last time, the configuration files cannot
be uploaded successfully this time. The system uploads the configuration files when the
next triggering time comes.

3.8 Software Version Upgrade

Note:
Normally, version upgrade is needed only when the original version does not support some
functions or the equipment operate abnormally due to some special causes. Improper
version upgrade operations may result in upgrade failure and startup failure of the system.
Therefore, before version upgrade, get familiar with the principles and operations of the
ZXR10 2900E and master the upgrade procedure.
3-11
SJ-20120409144109-002|2012-07-02(R1.0) ZTE Proprietary and Confidential