Zte ZXR10 2910E-PS Configuration Manual page 59

Command
zte(cfg)#create vlan <1-4094> name <name>
zte(cfg)#clear vlan <vlanlist> name
zte(cfg)#clear vlan protocol-mapping session-no <1-8>
show vlan [<vlanlist>] (all configuration modes)
show vlan protocol-mapping (all configuration modes)
VLAN Configuration Example One
l Configuration Description
Configure VLAN 100. Add untagged ports 1 and 2 and tagged ports 7 and 8. The
detailed configuration is as follows:
Note:
By default, VLAN1 is enabled, all ports are in VLAN1 and in untag mode.
l
Configuration Procedure
zte(cfg)#set vlan 100 add port 1, 2 untag
zte(cfg)#set vlan 100 add port 7, 8 tag
zte(cfg)#set port 1, 2 pvid 100
zte(cfg)#set vlan 100 enable
l
Configuration Verification
zte(cfg)#show vlan 100
VlanId
VlanName:
VlanMode:
Tagged ports
Untagged ports: 1-2
Forbidden ports:
VLAN Configuration Example Two
l
Configuration Description
As shown in
of switch A and port 2 of switch B are members of VLAN 2. Port 3 of switch A and
port 4 of switch B are members of VLAN 3. The members in the same VLAN can
communicate with each other.
SJ-20120409144109-002|2012-07-02(R1.0)
: 100 VlanStatus: enabled
Static
: 7-8
Figure 4-3, switch A is connected to switch B through port 16. Port 1
4-13
Chapter 4 Service Configuration
Function
Creates a VLAN name.
Clears a VLAN name.
Clears the VLAN template configuration
of the protocol.
Displays the basic VLAN information.
Displays the VLAN configuration of the
protocol.
ZTE Proprietary and Confidential