Zte ZXR10 2910E-PS Configuration Manual page 27

zte>?
enable
exit
help
show
list
zte>
2. Enter a question mark behind a character or string, commands or a list of keywords
starting with the character or string can be displayed. Note that there is no space
between the character (string) and the question mark. For example:
zte(cfg)#c?
cfm
zte(cfg)#c
3. Enter a question mark behind a command, a keyword or a parameter, the next keyword
or parameter to be input will be listed, and also a brief explanation will be given. Note
that a space must be entered before the question mark. For example:
zte(cfg)#config ?
egress-acl
group
ingress-acl
mac-based-vlan
nas
router
snmp
tffs
4. If you enter a wrong command, keyword, or parameter and press Enter, the message
"Command not found" will be displayed on the interface. For example:
zte(cfg)#conf ter
% Command not found (0x40000034)
In the following example, the online help is used to help create a username.
zte(cfg)#cre?
zte(cfg)#create ?
acl
cfm
port
protocol-protect
user
vlan
zte(cfg)#create user
% Parameter not enough (0x4000003f)
zte(cfg)#create user ?
<string>
user name(maxsize:15)
zte(cfg)#create user houyx ?
SJ-20120409144109-002|2012-07-02(R1.0)
enable configure mode
exit from user mode
description of the interactive help system
show config information
print command list
clear config cpu-threshold
create descriptive name for acl
create CFM information
create descriptive name for port
create a rule for protocol protect
create a user
create descriptive name for vlan
createconfig
enter egress acl config mode
enter group management config mode
enter ingress acl config mode
enter mac-based vlan config mode
enter nas config mode
enter router config mode
enter SNMP config mode
enter file system config mode
2-13
ZTE Proprietary and Confidential
Chapter 2 Usage and Operation
clear create