Zte ZXR10 2910E-PS Configuration Manual page 125

Command
zte(cfg)#set ntp {add | delete} trusted-key <1-255>
zte(cfg)#set ntp authenticate {enable | disable}
zte(cfg)#set ntp server <A.B.C.D>[version <1,2,3>| key <1-255>]
zte(cfg)#set ntp source <A.B.C.D>
zte(cfg)#set ntp clock-period <5-2147483647>
zte(cfg)#set ntp timezone <(-12)-(+13)>
zte(cfg)#set ntp {enable | disable}
zte(cfg)#set ntp src-udp-port {123 | 1000}
show ntp (all configuration modes)
NTP Configuration Instance
l
Configuration Description
Suppose that switch and NTP server (IP address is 202.10.10.10) implement
time synchronization. Make sure that switch and NTP server can ping each other
successfully. The NTP module is configured as follows:
l
Configuration Procedure
zte(cfg)#set ntp server 202.10.10.10
zte(cfg)#set ntp enable
l
Configuration Verification
zte(cfg)#show ntp
ntp protocol is enable
ntp server address
ntp source address
ntp source udp port : 1000
ntp is_synchronized
ntp rcv stratum
no reference clock.
ntp time zone
In the viewed information, ntp is-synchronized means if the current switch is
synchronized with server.
SJ-20120409144109-002|2012-07-02(R1.0)
: 202.10.10.10
: None
: No
: 16
: 0
4-79
Chapter 4 Service Configuration
Function
Adds or deletes NTP trusted-key.
Enables or disables NTP authentication
function.
Sets NTP server.
Sets the source IP address that is used
for switch to send NTP packet.
Sets the period of NTP synchronization.
Sets NTP time-zone.
Enables or disables NTP.
Sets the ID of the udp port through
which NTP messages are sent.
Displays NTP configuration.
ZTE Proprietary and Confidential