Zte ZXR10 2910E-PS Configuration Manual page 164

ZXR10 2900E Series Configuration Guide
Command
zte(cfg)#set vlan sqinq session <1-400> customer-port <port-id>
customer-vlan <vlan-list> uplink-vlan <vlan-id>
zte(cfg)#clear vlan sqinq
zte(cfg)#clear vlan sqinq session <1-400>
show vlan sqinq (all configuration modes)
show vlan sqinq session <1-400> (all configuration modes)
SQinQ Configuration Instance
l Configuration Description
Port 1 is a customer port, and port 2 is an uplink port. When CVLAN is 10 and 12, the
packet from port 1 SPVLAN is 997 and 998 respectively.
l
Configuration Procedure
Configure the SVLAN instance.
zte(cfg)#set vlan 10,12 add port 1 tag
zte(cfg)#set vlan 997,998 add port 1 untag
zte(cfg)#set vlan 997,998 add port 2 tag
zte(cfg)#set vlan 10,12,997,998 enable
zte(cfg)#set vlan sqinq session 1 customer-port 1 customer-vlan 10 uplink-vlan 997
zte(cfg)#set vlan sqinq session 2 customer-port 1 customer-vlan 12 uplink-vlan 998
l
Configuration Verification
The following example shows how to show the SVLAN instance.
zte(cfg)#show vlan sqinq
Session number
Customer Port
Customer Vlan List : 10
Uplink Vlan
Session number
Customer Port
Customer Vlan List : 12
Uplink Vlan
SJ-20120409144109-002|2012-07-02(R1.0)
: 1
: 1
: 997
: 2
: 1
: 998
4-118
Function
Enables SVLAN function.
When the SQinQ function is enabled,
the uplink traffic is normally forwarded
in SPVLAN. The downlink traffic
is normally forwarded in SPVLAN.
Because the UNI port belongs to
SPVLAN in untagged mode, the
SPVLAN tag of downlink packets will
be removed.
Deletes all SQinQ sessions.
Deletes the specified SQinQ session.
Displays all SQinQ sessions.
Displays the specified SQinQ session.
ZTE Proprietary and Confidential