Zte ZXR10 2910E-PS Configuration Manual page 43

zte(cfg-tffs)#cd ..
6. Use the command tftp to upgrade the version. The following shows how to download
the version file from the TFTP server to the FLASH memory:
zte(cfg-tffs)#cd img
zte(cfg-tffs)#tftp 10.40.89.78 download zImage
.................................................
.................................................
.................................................
7,384,016 bytes downloaded
zte(cfg-tffs)#ls
zte(cfg-tffs)#ls
/img/
.
..
zImage
7. Restart the switch. After successful startup, check the version under running and
confirm whether the upgrading is successful.
Version Upgrade When the System is Abnormal
If the switch cannot be started normally or runs abnormally, upgrade the version as follows:
1. Connect Console port of the switch to the serial port of the background host by using
the self-contained configuration cable. Connect an Ethernet port of the switch to the
network port of the background host by using a network cable. Check whether the
connections are correct.
2. Restart the switch. At the HyperTerminal, press any key as prompted to enter the
[ZXR10 Boot] status.
ZXR10 2928E BootRom Version v1.08
Compiled Feb 27 2012 10:32:29
Copyright (c) 2010 by ZTE Corporation.
boot location [0:Net,1:Flash] : 0
actport
serverip
netmask
ipaddr
bootfile
username
password
MAC : 00:d0:d0:3c:3b:00
SJ-20120409144109-002|2012-07-02(R1.0)
7,536,884 bytes
240,568,768 bytes free
: 1
: 10.40.89.78
: 255.255.255.0
: 10.40.89.100
: /img/zImage
: ZXR10
: 123456
3-13
Chapter 3 System Management
<DIR>
<DIR>
ZTE Proprietary and Confidential