Zte ZXR10 2910E-PS Configuration Manual page 209

Command
zte(cfg-snmp)#set host <A.B.C.D> trap {v1 <string>| v2c <string>|
v3 <string>{auth | noauth | priv}}
zte(cfg-snmp)#set host <A.B.C.D> inform { v2c <string>| v3
<string>{auth | noauth | priv}}
zte(cfg-snmp)#set trap {linkdown | linkup | authenticationfail
| coldstart | warmstart | topologychange | memberupdown
| portloopdetect | trunkloopdetect | linkMonitorStatus |
remoteLinkStatus | dyingGaspStatus | remoteDiscovery |
powerDown | dhcpCharCheck | cpuUserationThreshold |
memUserationThreshold | fanStatusCheck | macNotification |
udldUnidirectional | protocolProtect | dismanpingnotifications|
adminPasswordNoChange | arpOverload | bootfileLost
| cfmFaultAlarm | fanSpeed | fileTransfer | ipConflict |
MacOverload | poe | StpBridgeRoleChange | StpPortStateChange
| temperature | all}{enable | disable}
zte(cfg-snmp)#set group <string> v3 {auth | noauth | priv}[read
<string>[write <string>[notify <string>]]]
zte(cfg-snmp)#set user <string><string> v3 [md5-auth <string>|
sha-auth <string>[des56-priv <string>]]
zte(cfg-snmp)#set trap macnotification {port<1-51>|
trunk<1-15>}{enable|disable}
zte(cfg-snmp)#set trap macnotification {history-size<1-256>|
interval<1-3600>}
zte(cfg-snmp)#clear host <A.B.C.D>{trap | inform}<string>
zte(cfg-snmp)#clear community <string>
zte(cfg-snmp)#clear view <string>
zte(cfg-snmp)#clear group <string> v3 {auth | noauth | priv}
zte(cfg-snmp)#clear user <string> v3
zte(cfg-snmp)#clear engineID
show snmp (all configuration modes)
show snmp {community | engineID | group | host | trap | user |
view} (all configuration modes)
SJ-20120409144109-002|2012-07-02(R1.0)
5-9
ZTE Proprietary and Confidential
Chapter 5 Management
Function
Sets IP address, group name,
username and version of trap host
and inform host.
Sets host IP address, group name,
username and version of inform.
Enables/disables the function to
trap link connection/disconnection,
authentication failure, cool/hot
start/topology change, trunk
member UP/DOWN, loopback
detected at port/Trunk, MAC
number exceeding the threshold,
link monitor event alarms, remote
link event alarms, event detection
alarms, MAC list variation
notification, and ping notification.
Sets the SNMP V3 group name
and group security level.
Sets SNMP v3 user name,
authentication mode and password
Enables or disables MAC change
notification function on a specific
port or trunk.
Sets the number and interval of
MAC change notifications.
Clears a host configuration.
Clears a community name.
Clears a view.
Clears a group.
Clears a user.
Clears SNMP engine identifier and
recovers default value.
Displays all SNMP configuration
information.
Displays each element of SNMP
V1, V2C and V3.