Zte ZXR10 2910E-PS Configuration Manual page 244

ZXR10 2900E Series Configuration Guide
The M_button function includes the following modes:
1. LINK mode (LINK): In this mode, a port indicator displays the LINK/ACT status of a
port. If the port is in link status, the green indicator is lit. If there is traffic, the green
indicator is flashing. If the port is not in link status, the indicator is not lit.
2. SPD mode (SPD): In this mode, a port indicator displays the current speed of a port.
If the port speed is the same as the default port speed, the green indicator is lit. If not,
the yellow indicator is lit.
3. DUPLEX mode (DUP): In this mode, a port indicator displays the duplex status. If the
port is in full-duplex mode, the green indicator is lit. If the port is in half-duplex mode,
the yellow indicator is lit.
4. STA mode (STAT): In this mode, a port indicator displays the STP status. If the STP
status of the port is Forward, the green indicator is lit. If the STP status of the port is
Disable, the indicator is not lit. In other statuses, the yellow indicator is lit. The STA
status is the status of the port in Instance 0.
5. CPU usage mode (CUP%): In this mode, a port indicator displays the current CPU
usage. For the 2910E-PS, the first 8 ports display the current usage, each of which
represents 12.5%. For other devices, the first 10 ports display the current usage, each
of which represents 10%.
6. Memory usage mode (MEM%): In this mode, a port indicator displays the current
memory usage. For the 2910E-PS, the first 8 ports display the current usage, each
of which represents 12.5%. For other devices, the first 10 ports display the current
usage, each of which represents 10%.
7. Uplink port outbound bandwidth occupation rate mode (↑BW%): In this mode, a port
indicator displays the current occupation rate of uplink port outbound bandwidth. The
current speed on the uplink interface is used as the base. For the 2910E-PS, the first
8 ports display the current occupation rate, each of which represents 12.5%. For other
devices, the first 10 ports display the current occupation rate, each of which represents
10%.
8. Uplink port inbound bandwidth occupation rate mode (↓BW%): In this mode, a port
indicator displays the current occupation rate of uplink port inbound bandwidth. The
current speed on the uplink interface is used as the base. For the 2910E-PS, the first
8 ports display the current occupation rate, each of which represents 12.5%. For other
devices, the first 10 ports display the current occupation rate, each of which represents
10%.
9. PING network management center mode (PING): In this mode, use the first five port
indicators. A device sends 5 ICMP packets to the network management center. For an
ICMP packet, if the correct reply is received, the corresponding indicator turns green.
If the correct reply is not received, the corresponding indicator turns yellow. When the
five indicators are all lit, and then they are not lit. After 20 seconds, the next PING flow
will start. If the network management address is not configured, the five indicators turn
yellow at the same time and then they are not lit. After 20 seconds, the next PING flow
will start.
SJ-20120409144109-002|2012-07-02(R1.0)
5-44
ZTE Proprietary and Confidential