Zte ZXR10 2910E-PS Configuration Manual page 167

Configuring VLAN Mapping
The VLAN mapping configuration includes the following commands:
Command
zte(cfg)#set vlan mapping session <session_id> customer-port <<port-id>
customer-vlan <vlan-list> uplink-vlan <vlan-id>
zte(cfg)#clear vlan mapping
zte(cfg)#clear vlan mapping session <1-400>
zte(cfg)#clear vlan mapping user
zte(cfg)#clear vlan mapping user session <1-400>
show vlan mapping (all configuration modes)
show vlan mapping session <1-400> (all configuration modes)
show vlan mapping user-table (all configuration modes)
show vlan mapping user-table session <1-400> (all configuration modes)
VLAN Mapping Configuration Instance
l Configuration Description
The port 1 is on customer network, and the port 24 is on service provider network, as
shown in
between 1-100, to SPVLAN 1000.
SJ-20120409144109-002|2012-07-02(R1.0)
Figure 4-48. Map the packets received from port 1, and whose CVLANs are
Chapter 4 Service Configuration
Function
Sets the VLAN Mapping function.
When the VLAN Mapping is enabled,
the uplink traffic is normally forwarded
in SPVLAN. The downlink traffic is
normally forwarded in SPVLAN. When
reaching the user port, it is transformed
to the corresponding CVLAN tag.
Deletes all VLAN Mapping sessions.
Deletes the specified VLAN Mapping
session.
Deletes the user information of all VLAN
Mapping sessions.
Deletes the user information of the
specified VLAN Mapping session.
Displays all VLAN Mapping sessions.
Displays the specified VLAN Mapping
session.
Displays the user information of all
VLAN Mapping sessions.
Displays the user information of the
specified VLAN Mapping session.
4-121
ZTE Proprietary and Confidential