Zte ZXR10 2910E-PS Configuration Manual page 160

ZXR10 2900E Series Configuration Guide
zte(cfg)#set ethernet-oam enable
zte(cfg)#set ethernet-oam port 2 enable
zte(cfg)#show Ethernet-oam port 2 discovery
/*the port mode must be active, or the discovery is failure*/
/*yes represents that discovery succeeds. no represents discovery fails.*/
/*discovery succeeds. "undone"represents that discovery fails*/
Mib Retrieval
Stable
Mac Address
/*the system MAC of the remote device.
The MAC address is 00.00.00.00.00.00 when discovery fails.*/
zte(cfg)#set ethernet-oam remote-loopback port 2 start
zte(cfg)#show ethernet-oam port 2 discovery
SJ-20120409144109-002|2012-07-02(R1.0)
PortId 2: ethernet oam enabled
Local DTE
-----------
Config:
Mode : active
Period : 10*100(ms)
Link TimeOut : 5(s)
Unidirection : nonsupport
PDU max size : 1518
Status:
Parser : forward
Multiplexer : forward
Stable : yes
Discovery : done
Loopback : off
PDU Revision : 92
Remote DTE
-----------
Config:
Mode : active
Link Monitor : support
Unidirection : nonsupport
Remote Loopback : support
: nonsupport
PDU max size : 1518
Status:
Parser : forward
Multiplexer : forward
: yes
: 00.d0.d0.29.28.02
PDU Revision : 967
PortId 2: ethernet oam enabled
Local DTE
-----------
/*the local device information*/
/*the remote device information*/
4-114
ZTE Proprietary and Confidential