Zte ZXR10 2910E-PS Configuration Manual page 161

/*the local is the active originator (Master).
The other end displays as slave.*/
zte(cfg)#set ethernet-oam remote-loopback port 2 stop
/*disable OAM remote-loopback on port2.
The switch replies OAM discovery success.*/
The key points of configuration:
The switch gives the following prompts when OAM discovery failure occurs, or starting
and stopping remote loopback.
OAM discovery is completed successfully on port 2, the following information appears.
SAT JUL 03 23:30:00 2004 ETH-OAM port 2's discovery process is successful.
Disconnect the network cable between switches, the following information appears.
SAT JUL 03 23:33:00 2004 ETH-OAM port 2 deteced
a fault in the local receive direction.
SJ-20120409144109-002|2012-07-02(R1.0)
Config:
Mode : active
Period : 10*100(ms)
Link TimeOut : 5(s)
Unidirection : nonsupport
PDU max size : 1518
Status:
Parser : discard
Multiplexer : forward
Stable : yes
Discovery : done
Loopback : on(Master)
PDU Revision : 1431
Remote DTE
-----------
Config:
Mode : active
Link Monitor : support
Unidirection : nonsupport
Remote Loopback : support
Mib Retrieval : nonsupport
PDU max size : 1518
Status:
Parser : loopback
Multiplexer : discard
Stable : yes
Mac Address : 00.d0.d0.29.28.02
PDU Revision : 28
Chapter 4 Service Configuration
/*the parser state is discard*/
/*the parser state is loopback*/
/*the multiplexer state is discard*/
4-115
ZTE Proprietary and Confidential