Zte ZXR10 2910E-PS Configuration Manual page 146

ZXR10 2900E Series Configuration Guide
No more than 4 areas in one node
à
No more than 3 layers in one node
à
No more than 3 layers in one area
à
No more than 4 lower layer access ports in one node
à
No more than 8 ZESR ports in one node
à
When the protocol port of ZESR node is enabled and configured (including
à
master and slave port, edge port, access port), other services, such as adding
aggregation port group, enabling port security, port rate limit and enabling loop
detection cannot be configured on this protocol port.
Configuring ZESR
The ZESR configuration includes the following commands:
Command
zte(cfg)#set zesr domain <1-4>{add | delete} control-vlan <vlanId>
zte(cfg)#set zesr domain <1-4>{add | delete} protect-instance <1-15>
zte(cfg)#set zesr domain <1-4>{add | delete}{primary-port <1-28>|
primary-trunk <1-15>| secondary-port <1-28>| secondary-trunk
<1-15>}
zte(cfg)#set zesr domain <1-4>{add | delete}{access-port <1-28>|
access-trunk <1-15>}
zte(cfg)#set zesr domain <1-4> mode smart-link
zte(cfg)#set zesr domain<1-4> major-level mode {master | transit |
edge-master | edge-transit}
zte(cfg)#set zesr domain <1-4> major-level preforward-timer <3-600>
preup-timer <0-500> linkdown-failtimer <8-500>
zte(cfg)#set zesr domain <1-4> level <1-2> segment<1-4> mode {master |
transit | edge-master | edge-transit}
zte(cfg)#set zesr domain <1-4> level <1-2> segment <1-4>{add |
delete}{edge-port <1-28>| edge-trunk <1-15>}[notmaster | master]
zte(cfg)#set zesr domain <1-4> level <1-2> segment <1-4>
preforward-timer <3-600> preup-timer <0-500> linkdown-failtimer
<8-500>
SJ-20120409144109-002|2012-07-02(R1.0)
Note:
Function
Adds or deletes ZESR domain control
VLAN.
Adds or deletes the MSTP instance that
ZESR requires to protect.
Adds or deletes primary/secondary
port/trunk on each node.
Adds or deletes SMART-LINK access
port/trunk on the ZESR ring node.
Sets node type as SMART-LINK.
Sets the node attribute of major-level.
Sets preforward-timer, preup-timer and
linkdown-failtimer on the primary ring.
Sets the node attribute of secondary
ring.
Adds or deletes the edge port of the
secondary ring.
Sets preforward-timer, preup-timer and
linkdown-failtimer of the secondary ring.
4-100
ZTE Proprietary and Confidential