Zte ZXR10 2910E-PS Configuration Manual page 223

Command
zte(cfg)#set sFlow collector-address <A.B.C.D>
zte(cfg)#set sFlow {ingress | egress}{enable | disable}
zte(cfg)#set sFlow {ingress | egress} reload-mode {continue | cpu}
zte(cfg)#set sFlow {ingress | egress} port <portlist> packet-sample
{off | frequency <2-16000000>}
zte(cfg)#set sFlow ingress sample-mode {all | forward}
zte(cfg)#clear sFlow config
zte(cfg)#clear sFlow statistic
show sFlow (all configuration modes)
5.8 WEB
WEB Management Overview
ZXR10 2900E provides an embedded Web server stored in flash memory, which allows
user to use a standard Web browser (it is recommended to use IE6.0 above and 1024×768
resolution) for managing remote switch.
Configuring System Login
On the condition that WEB connection has been configured on the switch .
1. Open Microsoft Internet Explore.
2. Enter the IP address of the switch in the address bar (this address is that switch can
connect) to open the system login interface, as shown in
SJ-20120409144109-002|2012-07-02(R1.0)
5-23
ZTE Proprietary and Confidential
Chapter 5 Management
Function
Sets IP address of sFlow collector.
Enables or disables ingress/egress
sFlow function.
Sets sampling mode on
ingress/egress direction.
Sets sampling rate on
ingress/egress direction of
gigabit port.
Sets the packet range on ingress
direction.
Clears all sFlow configuration and
recovers as default state.
Clears sFlow port sampling
statistics.
Displays sFlow configuration
information.
Figure 5-10.