Zte ZXR10 2910E-PS Configuration Manual page 44

ZXR10 2900E Series Configuration Guide
[ZXR10 Boot]
3. Enter c in the ZX10 Boot status and press Enter to enter the parameter modification
status. Set the IP addresses of the Ethernet port and the TFTP server. The two
addresses are set to be in the same network segment.
[ZXR10 Boot]: c
boot location [0:Net,1:Flash] :
0/*start by tftp or flash */
actport
/*select the panel port that tftp enables*/
serverip
/*ftp/tftp server address*/
netmask
/*subnet mask*/
ipaddr
/*local interface address*/
bootfile
/*version file location*/
username
/*the username when the file is downloaded by ftp*/
password
/*the password when the file is downloaded by ftp */
MAC
/*Switch MAC address*/
4. Set the IP address of the back-end host to be the same as that of the above TFTP
server.
5. Start the TFTP server software on the back-end server and configure the TFTP by
referring to the TFTP configuration.
6. In the ZX10 Boot status, enter zte, enter the BootManager status of the switch. Enter
? to display the command list for this state.
[ZXR10 Boot]:zte
[bootManager]: ?
?
cd
exit
format
ftp
help
l
ls
mv
reboot
rm
setBOOTpassword - set password for BOOT mode
setPtype- set packaged type
show
SJ-20120409144109-002|2012-07-02(R1.0)
- alias for 'help'
- change current path
- exit from bootManager mode
- format flash
- get/put file from/to FTP server
- print online help
- load zImage
- list files in current directory
- change [source] name to [destination] name
- perform REBOOT of the CPU
- remove file
- show board information
: 1
: 10.40.89.78
: 255.255.255.0
: 10.40.89.79
: /img/zImage
: ZXR10
: ZXR10
: 00:d0:d0:30:20:10
3-14
ZTE Proprietary and Confidential