Zte ZXR10 2910E-PS Configuration Manual page 152

ZXR10 2900E Series Configuration Guide
zxr10(cfg)#set zesr domain 1 add secondary-port 2
zxr10(cfg)#set zesr domain 1 level 1 segment 2 mode master
zxr10(cfg)#set zesr domain 1 enable
5. S6 node
/*VLAN*/
zxr10(cfg)#set vlan 100 add port 1, 2
zxr10(cfg)#set vlan 4000 add port 1, 2 tag
zxr10(cfg)#set vlan 100, 4000 enable
zxr10(cfg)#set port 1, 2 pvid 100
/*STP*/
zxr10(cfg)#set stp instance 1 add vlan 100
zxr10(cfg)#set stp enable
/*ZESR*/
zxr10(cfg)#set zesr domain 1 add control-vlan 4000
zxr10(cfg)#set zesr domain 1 add protect-instance 1
zxr10(cfg)#set zesr domain 1 add primary-port 1
zxr10(cfg)#set zesr domain 1 add secondary-port 2
zxr10(cfg)#set zesr domain 1 level 1 segment 1 mode master
zxr10(cfg)#set zesr domain 1 enable
1. The intersecting node of the primary ring and the hierarchical ring must be
Edge-Port or Edge-Transit.
2. The port connecting the primary ring and the hierarchical ring must be Edge-Port.
3. The edge-port has two attributes: not Master and Master. The attribute not Master
is used in the condition that the master of the hierarchical ring exists. Master is
used in the condition that the master does not exist and the edge-port master
serves as the master.
4. The edge-port with Master attribute must be set on edge-master.
ZESR Smart Link Networking Example
l
Configuration Description
This example describes how to configure ZESR smart link networking domain. The
smart link networking composed of 5 switches is shown in
ZESR primary ring and one smart link node.
1. The primary ring is composed of nodes S1~S4.
PrimaryPort, P2 is the SecondaryPort, S2 is the Transit node, S3~S4 are
Edge-Transit node, P3 is the Access port using for Smart Link.
2. S5 is the Smart Link node. P1 is the PrimaryPort. P2 is the SecondaryPort.
The protect instance in the ring is 1, the protected data is VLAN 100 and the protocol
VLAN is VLAN 4000.
SJ-20120409144109-002|2012-07-02(R1.0)
Note:
4-106
ZTE Proprietary and Confidential
Figure 4-43. There are one
S1 is Master, P1 is the