Zte ZXR10 2910E-PS Configuration Manual page 201

Chapter 5
Management
Table of Contents
REMOTE-ACCESS ....................................................................................................5-1
SSH ...........................................................................................................................5-3
PRIVILEGE ................................................................................................................5-6
SNMP Overview.........................................................................................................5-7
RMON Overview ......................................................................................................5-12
ZGMP ......................................................................................................................5-15
sFlow .......................................................................................................................5-22
WEB.........................................................................................................................5-23
M_Button..................................................................................................................5-43
Telnet .......................................................................................................................5-45
5.1 REMOTE-ACCESS
Remote-Access Overview
Remote-Access is a restrictive mechanism used for network management users to log in
through Telnet, SSH, SNMP and Web, that is, it is used to restrict the access. This function
is to enhance the security of the network management system.
After this function is enabled, specify a network management user to access the switch
only from a specified IP address , the user cannot access the switch from other IP
addresses. When this function is disabled, the network management user can access the
switch through Telnet, SSH, SNMP and Web from any IP address.
Configuring REMOTE-ACCESS
The REMOTE-ACCESS configuration includes the following commands:
Command
zte(cfg)#set remote-access {any | specific}
zte(cfg)#set remote-access ipaddress <A.B.C.D>[<A.B.C.D>][{snmp
| telnet | ssh | web}{permit | deny}]
zte(cfg)#clear remote-access all
SJ-20120409144109-002|2012-07-02(R1.0)
5-1
ZTE Proprietary and Confidential
Function
Enables or disable remote access
control function.
Permits or denies the login mode
of IP address.
Deletes all IP address
configuration.