Zte ZXR10 2910E-PS Configuration Manual page 147

Command
zte(cfg)#set zesr domain <1-4> linkhello {add | delete} port <1-28>
zte(cfg)#set zesr domain <1-4> linkhello-timer <1-3> linkhello-failtimer
<3-9>
zte(cfg)#set zesr domain <1-4> linkhello {enable | disable}
zte(cfg)#set zesr domain <1-4>{enable | disable}
zte(cfg)#set zesr domain <domainId> major-level mode {zess-master|zess-tr
ansit|zess-edge-master |zess-edge-transit}
zte(cfg)#set zesr domain <domainId> level <levelId> segment <segId>
mode {zess-master|zess-transit| zess-edge-master|zess-edge-transit}
zte(cfg)#set zesr domain <domainId> tcn {cancel-sending|sending}
zte(cfg)#set zesr tcn-sending port <portlist>{enable|disable}
zte(cfg)#set zesr tcn-sending trunk <trunklist>{enable|disable}
zte(cfg)#set zesr protocol-mac {normal|special}
zte(cfg)#clear zesr domain <1-4>
show zesr domain [<1-4>] (all configuration modes)
ZESR Single Ring Networking Example
l
Configuration Description
As shown in
Port. S2~S4 are Transit nodes. The protect instance in the ring is 1, the protected
data VLAN is 100 and the protocol control VLAN is 4000.
SJ-20120409144109-002|2012-07-02(R1.0)
Figure 4-41, S1 is Master node, P1 is Primary Port, P2 is Secondary
4-101
Chapter 4 Service Configuration
Function
Adds or deletes linkhello port.
Sets linkhello packet sending interval
and linkhello mechanism timeout.
Enables or disables linkhello
mechanism.
Enables or disables ZESR domain.
Sets the attribute of a node on the
major-level ring on a cross-device
smart-link.
Sets the attributes of the nodes on the
slavery device ring under cross-device
smart-link.
Sets the mode to send TCN in a ZESR
domain.
Enables or disables a port to send TCN
packets.
Enables or disables a trunk port to send
TCN packets.
Sets the ZESR protocol MAC mode.
Deletes ZESR domain.
Displays ZESR configuration.
ZTE Proprietary and Confidential