Gefen Multiview EXT-HD-MVSL-441 User Manual page 81

Advanced Operation Chapter
Command
#set_saturation
#set_tcp_user
#set_telnet_pass
#set_telnet_port
#set_udp_port
#set_udp_remote_ip
#set_udp_remote_port
#set_vposition
#set_vsize
#set_webui_ad_pass
#set_webui_op_pass
#show_bank_name
#show_brightness
#show_chromakey_color
#show_contrast
#show_gateway
#show_hdcp
#show_http_port
#show_hue
#show_ip
#show_ipconfig
#show_ipmode
#show_ir
#show_mac_addr
#show_netmask
#show_osd
#show_output
#show_power
#show_preset_name
#show_saturation
#show_tcp_access
#show_telnet_port
#show_udp_port
#show_udp_remote_ip
Description
Set the saturation for the specified output
This command will be available in a future release of
the firmware
Sets the Telnet password
Sets the Telnet listening port
Sets the local UDP listening port
Sets the remote UDP IP address
Sets the remote UDP port
Sets the vertical position of the specified window
Sets the vertical size of the specified window
Sets the Administrator password for the Web
interface
Sets the Operator password for the Web interface
Displays the name of the specified EDID bank
Displays the brightness value for all outputs
Displays the minimum or maximum value of the
specified chroma key color component
Displays the contrast value for all outputs
Displays the IP address of the (router) gateway
Displays the HDCP status of the specified input
Displays the Web server listening port
Displays the hue value for all outputs
Displays the current IP address of the switcher
Displays the current TCP/IP settings of the switcher
Displays the current IP mode (DHCP or static)
Displays the current IR channel of the switcher
Displays the MAC address of the switcher
Displays the current subnet mask
Enables or disables the OSD (On-Screen Display)
Displays the output resolution
Displays the power state of the switcher
Displays the name of the specified preset
Displays the saturation value for all outputs
Displays the current TCP access state
Displays the current Telnet port
Displays the current UDP serial port
Displays the current UDP remote IP address
page | 71
Commands