Table of Contents
Advertisement
3.6 Making Default Settings
3.6.5
Default Font
10
Press the MENU key. The display returns to Ready.
You can select the default font for the current interface. The default font can be one of the
internal fonts or a font that is downloaded to the printer memory or stored on memory card or
hard disk.
In this menu, you can also set the type and pitch for Courier and Letter Gothic; as well as to
print a font list.
1
Press the MENU key.
2
Press the
or
Font
3
Press the
key. Press the
>Font Select
Internal
4
To select an internal font, make sure that Internal is displayed and press the
The display changes as shown below. If Internal is not displayed, Press the ENTER
key, then press the
>> I000
To select an optional font, press the ENTER key while >Font Select > is
displayed. Press the
ENTER key. Press the
perform this operation only when optional fonts are installed in the printer.
The letter before the number indicates the location of the font, as shown below:
Internal font
I
Soft (downloaded) font
S
Fonts in optional memory card
M
Fonts in RAM disk or optional hard disk
H
Fonts in optional ROM (API)
O
5
Press the ENTER key. A blinking question mark (?) appears.
>>?I000
key repeatedly until Font > appears.
>
or
key until >Font Select > appears.
>
or
key until it appears.
or
key repeatedly until Option appears and then press the
key next to display the font selection shown above. You can
3-52
key.
Advertisement
Table of Contents
