Table of Contents
Advertisement
3.1.2
Indicators in Message Display
Message
Please wait
(Calibrating)
Ready
Processing
Sleeping
Cancelling data
Waiting
FormFeed TimeOut
Table 3-1 (Continued)
Error codes
See
Chapter 5
Troubleshooting.
Figure 3-2
Interface Indicator (INTERFACE)
The interface indicator shows the interface that is currently in use:
PAR
Parallel interface is in use.
SER
Serial (RS-232C) interface is in use.
OP1 (2)
Network interface is in use.
---
No interface is in use.
Each interface has a timeout time of 30 seconds during which the other interface should wait to
receive a print job. Even a print job has been complete on the interface, you should wait for
this period until the other interface begins printing the job.
Meaning
The color calibration function is being performed automati-
cally as you powered on the printer.
You can also execute this function manually on the operator
panel. For details, see
Section 3.11.4 Color Calibration on
page
3-100.
The printer is ready to print.
The printer is receiving data to print. This is also shown when
the printer is reading a memory card or hard disk.
The printer is in sleep mode. The printer wakes from sleep
mode whenever a key on the operator panel is pressed, the
cover is opened or closed, or a print job is received. The printer
then warms up and goes on-line. For details on sleep mode, see
Section Sleep Timer Timeout Time on page
Jobs inside the printer are being canceled. To cancel a job, see
Section 3.1.3 Keys on page 3-6
The printer is waiting for the rest of print job before complet-
ing the last page. Pressing the GO key allows you to obtain the
last page immediately. See below.
The printer is printing the last page after a waiting period.
3-3
3.1 Understanding the Operator Panel
3-107.
.
Advertisement
Table of Contents
