Table of Contents
Advertisement
5.3
Error Messages
5.3.1
Error Messages
The tables on the following pages indicate how to respond to problems indicated by the
operator panel indicators and messages.
The following table lists errors and maintenance messages that can be dealt with by yourself. If
Call service appears, turn off the printer, disconnect the power cord, and contact your
Kyocera Mita dealer.
Some errors cause the alarm sound to sound. To stop the alarm sound, press the CANCEL key
to stop the alarm sound.
Message
Add paper (paper source) The paper has run out in the paper source displayed. Supply paper accord-
Add staples
Press GO
Call service
####:0123456
Call service
F###:0123456
Call service
Person
F0
Cassette #
not loaded
Check waste toner
bottle
Clean printer
Press GO
Duplex drawer
not loaded
Face-down tray
paper full
Table 5-3
Corrective Action
ing to the paper source displayed (paper cassettes, MP tray, or optional
paper feeders).
This message is displayed alternately with messages indicating the printer
status, such as, Ready, Please wait, Processing, Waiting, and
Form Feed Time Out. If the number of copies to print is 2 or more,
only the Add paper message is displayed.
The optional document finisher has run out of staples. Replenish staples
and press the GO key.
#### represents a mechanical error (#=0, 1, 2, ...). Call a service. The
printer does not operate when this message is displayed. The total number
of pages printed is also indicated, e.g. 0123456.
F### represents a controller error (#=0, 1, 2, ...). Call a service. The
printer does not operate when this message is displayed.
This message means an error in data communications between the printer
controller and the operator panel. Call a service.
The corresponding paper cassette is not installed. Install the cassette. The
cassette number can be 1 (topmost) to 6 (bottom); and for the duplexer
model, 2 to 6.
This message warns following two cases. Install the new waste toner bottle.
•
The waster toner bottle is not installed.
•
The waste toner bottle is almost full.
The printer has reached the schedule to conduct cleaning. Clean the inside
of the printer . See
Chapter 6 Maintenance, section 6.5 Cleaning the
Printer on page
6-16. This message will be automatically displayed when
replacing the toner container after the message Replace toner TK-
82 is displayed. After cleaning the inside of the printer, press the GO key
and the printer will resume printing.
The duplex drawer is not installed. Install the duplex drawer. This message
is applicable to the duplexer model.
The face-down tray has become full (approx. 500 pages). You must
remove all printed pages from the face-down tray. When the printer senses
that the face-down tray is empty again, the printer will continues printing
into the face-down tray.
5-7
5.3 Error Messages
Advertisement
Table of Contents
