Table of Contents
Advertisement
B.4 RS-232C Cable Connection
5
The Properties sheet is displayed for the selected COM port. Select the Port
Settings tab and set the port properties.
Figure B-2
6
After setting the properties, click OK.
Using DOS for Serial Connection
To set the computer's serial parameters to, for example, 9600 bps, etc., at the DOS
command prompt, enter the following:
C:\>MODE COM1:96, N, 8, 1, P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
B-10
Advertisement
Table of Contents
