Table of Contents
Advertisement
3.5 Changing the Interface Parameters
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Opt. StatusPage
On
7
Activate the appropriate protocol that is required to connect the printer to the network.
To activate a protocol, let the protocol displayed, press the ENTER key, press the
key to change from Off to On, and press the ENTER key.
8
Press the MENU key. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway address have
been properly set. To print a network status page, see
Card Status Page on page 3-44
Range
Set this item to On when you connect to a network
>
using NetWare. In submenu (>), frame mode can be
selected from Auto, Ethernet, 802.2, and
802.3.
Set this item to On when you connect to a network
>
using TCP/IP. Submenu (>) has items including
DHCP, IP address, subnet mask address, and gate-
way address. To resolve IP address for the network
card, see
EtherTalk must be activated (On) for networking
with Macintosh computers.
When the item is set to On, the printer prints out a net-
work status page when it prints the printer status.
which follows.
3-42
3.5.4 Resolving IP Address
Printing a Network Interface
below.
or
Advertisement
Table of Contents
