Table of Contents
Advertisement
3.5.4
Resolving IP Address
To connect the printer to the network using TCP/IP protocol, you must set the IP address on
the printer. The IP address must be unique to the printer and should be obtained from your
network administrator.
1
Activate TCP/IP protocol in the manner described above.
>TCP/IP
On
2
Enter the submenu by pressing the
selection changes as shown below.
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
3
When >>IP Address is displayed, press the ENTER key. A bliking cursor (_)
appears at the last digit.
>>IP Address
000.000.000.000
4
Press the
or
cursor. Use the
5
When the IP address is entered, press the ENTER key.
6
Press the
or
complete entering the subnet mask address.
>
key. Each time you press the
key to increase or decrease, respectively, the value at the blinking
and
keys to move the cursor right and left.
key to move to Subnet Mask. Perform the same procedure to
3-43
3.5 Changing the Interface Parameters
or
key, the
Advertisement
Table of Contents
