Corrective Action - Kyocera Mita FS-8000CD Operation Manual

Printed Results
Grey background
Dirt on the top edge or back of the paper
Printing incomplete or out of position
Table 5-2 (Continued)

Corrective Action

Clean the main charger and the separation charger.
Open the printer front cover. Pull the green clean-
ing knob slowly in and out a few times. For full
details, see
Cleaning the Main Charger Unit on page
Conduct color calibration either by switching the
printer off then on or using the printer operator
panel (MENU). For full details, see
Using the Operator Panel, section 3.11.4 Color
Calibration on page
Clean the rubber belts. See below. For details, see
Chapter 6 Maintenance, section 6.5.1 Cleaning the
Paper Feed Unit on page
Clean the main charger and the separation charger.
Open the printer front cover. Pull the green clean-
ing knob slowly in and out a few times. For full
details, see
Cleaning the Main Charger Unit on page
Clean the parts in the paper paths—such as the
paper cassette, etc.
Check secondary the transfer roller.
If the secondary transfer roller is dirty with toner,
try printing several pages.
Check that the application software is correctly
operated.
See 5.1.1 Tips on page
5-5
5.2 Print Quality Problems
Chapter 6 Maintenance, section 6.5.2
Chapter 3
3-100.
6-16.
Chapter 6 Maintenance, section 6.5.2
5-2.
6-20.
6-20.