3.5 Changing the Interface Parameters
3.5
Changing the Interface Parameters
3.5.1
Changing Parallel Interface Mode
Communication parameters for the printer interfaces can be adjusted as explained below.
The FS-8000CN has an network interface card installed at the factory. For information on how
to remotely change parameters for the network interface card, refer to the documentation
supplied with the printer.
The parallel interface supports a bi-directional/high-speed mode according to IEEE standards.
You can select from the following:
•
Auto (default)
•
Nibble/high speed
•
Normal
•
High speed
In order for the change to take place, you must turn printer power once off then on.
1
Press the MENU key.
2
Press the
or
3
If the interface is other than parallel, press the ENTER key. A blinking question mark
(?) appears.
Interface
? Serial
4
Press the
or
Interface
? Parallel
5
Press the ENTER key again. The question mark disappears.
6
To change the parallel interface mode, press the
mode appears.
key repeatedly until Interface > appears.
key repeatedly until Parallel appears.
3-38
key. The current communication