Table of Contents
Advertisement
CHAPTER 5
The */Menu key on the operation panel can be used to configure settings such as the paper width and media type for each of the paper trays, the
printer's IP address, etc.
Based on their content, settings are divided into "Machine settings" that configure the printer's operation and "Printer settings" that configure the
printer's IP address and related network information. In addition they are divided according access privilege: there is a subset that offers limited
control to any "User", while full access to all settings is reserved for the "Manager". Input of the pin code is required for the manager to configure
settings.
For a description of each setting, see "(1) List of Machine Settings" and "(1) List of Printer Settings" (Page 5-11).
1. Machine Default
(1) List of Machine Settings
G Settings common to user/manager
Setting
1. Paper width
If this item is set to "Input size", a non-standard paper width
can be set. Use the N or M key to enter the paper width for
each paper source.
2. Media Type
If this item is set to "ON", a media type can be registered for
[Pre-set Temp.]
each paper source. Fixing temperature, print size, and fix/
unfix of roll end will be set based on the registered paper
material.
3. Paper type
If "2. Media Type [Pre-set Temp.]" is set to "ON", a media
[Paper
type can be set for each paper source including the bypass
material]
table.
If "Custom" is selected, fixing temperature, print size, etc. will
be set based on "8. Custom paper".
4. Roll end
This item sets whether or not paper roll end is fixed to the
core of the roll. If "Fixed" is selected, paper will be
automatically cut when paper runs out.
MANAGEMENT AND
SETTING
Description
Selectable values
Default
For each paper
Auto size
source:
Auto size/
Input size (17"~36"
[210mm~920mm])
ON/OFF
OFF
For each paper
Plain
source:
Plain/Vellum/
Film/Custom
For each paper
Unfix [Unfixed]
material:
(Film: Fixed)
Unfix [Unfixed]/
Fixed
Page
5-6
5-6
5-6
5-7
5-1
Advertisement
Table of Contents
Troubleshooting
