Configuring The Network Printer - Kyocera Mita FS-8000CD Operation Manual

4.5 Configuring the Network Printer

4.5 Configuring the Network Printer
If you have installed an option network interface card on the FS-8000C or purchased a FS-
8000CN (network model), you can attach and configure the printer on a network.
To successfully configure the network printer, you will have to:
• Install the network interface card in the printer (except for the FS-8000CN)
• Set the IP address, netmask, and gate way
• Activate the appropriate network protocol (TCP/IP, Novell NetWare, AppleTalk, etc.)
using the software (supplied with the network interface card)
• Share the printer on the network, if desired
You can use the instructions provided with the option card to complete these steps. In
general, the information you will be required to enter during these steps must be obtained
from your network administrator.
To set the IP address, netmask, and gateway, using the printer operator panel, see
Using the Operator Panel, section 3.5.4 Resolving IP Address on page 3-43
To print a network status page, see
Network Interface Card Status Page on page
Chapter 3 Using the Operator Panel, Printing a
3-44.
4-16
Chapter 3
.